Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR

STEERING GEAR > INSPECTION

for Preparation Click here



1. INSPECT TIE ROD END SUB-ASSEMBLY LH


C132329
  1. Secure the tie rod end LH in a vise.

  1. Install the nut to the stud bolt.

  1. Flip the ball joint back and forth 5 times or more.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

    Standard turning torque:
    1.0 to 3.9 N*m (10 to 40 kgf*cm, 9 to 34 in.*lbf)

    If turning torque is not within the specified range, replace the tie rod end LH.



2. INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.