Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY

FRONT PROPELLER SHAFT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY


    C158559
  1. Check that the propeller shaft is not damaged or deformed.

    1. If necessary, replace the propeller shaft.

  1. Using a dial indicator, check the propeller shaft runout.

    Maximum runout:
    0.61 mm (0.0240 in.)



2. INSPECT UNIVERSAL JOINT SPIDER BEARING
  1. Check that the joints move smoothly.

  1. Check the spider bearings for wear and damage.

  1. Check the spider bearing axial play by turning the yoke while holding the shaft tightly.

    Maximum bearing axial play:
    0.05 mm (0.00197 in.)

    1. If necessary, replace the spider bearing.



3. REMOVE FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER


    C158560E03
  1. Place matchmarks on the universal joint flange yoke and propeller shaft's universal joint flange yoke.



    C158561
  1. Using a brass bar and hammer, slightly tap in the universal joint spider bearing.

  1. Using needle-nose pliers, remove the 4 hole snap rings from the grooves.



    F015025E09
  1. Using SST, push out the universal joint spider bearing from the shaft's universal joint flange yoke.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



    F044192E02
  1. Clamp the universal joint spider bearing in a vise and tap off the propeller shaft with a hammer.

    NOTICE:
    Do not tap the shaft tube.

    HINT:
    Use the same removal procedure for the universal joint spider bearing on the opposite side.

  1. Install the 2 removed universal joint spider bearing to the universal joint spider.



    F015030E08
  1. Using SST, push the universal joint spider bearing out of the universal joint flange yoke.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



    C158562E01
  1. Clamp the universal joint spider bearing in a vise and tap off the universal joint flange yoke with a hammer.

  1. Remove the universal joint spider.

    HINT:
    Use the same removal procedure for the universal joint spider on the opposite side.