FRONT PROPELLER SHAFT ASSEMBLY > REASSEMBLY |
| 1. INSTALL FRONT PROPELLER SHAFT UNIVERSAL J0INT SPIDER |
![]() |
Apply MP grease to a new universal joint spider and universal joint spider bearings.
![]() |
Measure dimension A between the snap ring grooves.
Install the universal joint spider bearing into the universal joint spider and measure dimension B.
![]() |
Select hole snap rings of the correct thickness to make dimensions A and B the same.
| Color | Thickness mm (in.) |
| Green | 1.384 mm (0.0545 in.) |
| Red | 1.435 mm (0.0565 in.) |
| Black | 1.486 mm (0.0585 in.) |
| Copper | 1.511 mm (0.0595 in.) |
| Silver | 1.537 mm (0.0605 in.) |
| Yellow | 1.588 mm (0.0625 in.) |
| Blue | 1.638 mm (0.0645 in.) |
![]() |
Insert the universal joint spider into the universal joint flange yoke, and then using SST, press in the universal joint spider bearing into the snap ring groove.
![]() |
Using needle-nose pliers, install new hole snap rings into the snap ring grooves of the yoke.
| 2. INSPECT PROPELLER SHAFT GREASE FITTING DIRECTION |

| 3. INSPECT UNIVERSAL JOINT SPIDER BEARING |
Check that the joints move smoothly.
Check the spider bearings for wear and damage.
Check the spider bearing axial play by turning the yoke while holding the shaft tightly.