Home › Drivetrain ยท JF3A TRANSFER / 4WD / AWD › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT TRANSFER INPUT SHAFT


    C180912
  1. Using a micrometer, measure the diameter of the transfer input shaft journal surface.

    Minimum diameter:
    68.002 mm (2.678 in.)

    If the diameter is less than the minimum, replace the transfer input shaft.



    C180913
  1. Using a dial indicator, measure the inside diameter of the transfer input shaft bimetal formed bush.

    Maximum inside diameter:
    46 mm (1.811 in.)

    If the inside diameter is more than the maximum, replace the transfer input shaft.



2. INSPECT TRANSFER LOW PLANETARY GEAR ASSEMBLY


    C180914
  1. Using a feeler gauge, measure the thrust clearance of the pinion gear.

    Standard clearance:
    0.11 to 0.85 mm (0.00434 to 0.0334 in.)

    Maximum clearance:
    0.85 mm (0.0334 in.)

    If the clearance is more than the maximum, replace the transfer low planetary gear assembly.



3. INSPECT TRANSFER LOW PLANETARY GEAR ASSEMBLY


    C180915
  1. Using a dial indicator, measure the radial clearance of the pinion gear.

    Standard clearance:
    0.011 to 0.038 mm (0.000434 to 0.00150 in.)

    Maximum clearance:
    0.038 mm (0.00150 in.)

    If the clearance is more than the maximum, replace the transfer low planetary gear assembly.



4. INSPECT REAR TRANSFER OUTPUT SHAFT


    C180916E01
  1. Using a micrometer, measure the diameter of the rear transfer output shaft journal.

    Minimum Diameter:
    Journal
    Specified Condition
    A
    37.984 mm (1.496 in.)
    B
    41.984 mm (1.653 in.)
    C
    48.984 mm (1.928 in.)

    If the diameter is less than the minimum, replace the rear transfer output shaft.



5. INSPECT NO. 1 TRANSFER GEAR SHIFT FORK AND FRONT DRIVE CLUTCH SLEEVE


    C183215
  1. Using a feeler gauge, measure the clearance between the front drive clutch sleeve and No. 1 transfer gear shift fork.

    Maximum clearance:
    0.8 mm (0.0315 in.)

    If the clearance is more than the maximum, replace the front drive clutch sleeve or No. 1 transfer gear shift fork.



6. INSPECT NO. 2 TRANSFER GEAR SHIFT FORK AND HIGH AND LOW CLUTCH SLEEVE


    C183216
  1. Using a feeler gauge, measure the clearance between the transfer high and low clutch sleeve and No. 2 transfer gear shift fork.

    Maximum clearance:
    3 mm (0.118 in.)

    If the clearance is more than the maximum, replace the transfer high and low clutch sleeve or No. 2 transfer gear shift fork.



7. INSPECT TRANSFER SYNCHRONIZER RING SET


    C180917
  1. Apply gear oil to the cone of the transfer drive sprocket sub-assembly, and check that it does not turn in both directions while pushing the transfer synchronizer ring set.
    If it can turn, replace the transfer synchronizer ring set.



    C180918
  1. Push the transfer synchronizer ring set to the cone of the transfer drive sprocket sub-assembly. Measure the clearance between the transfer synchronizer ring set and transfer drive sprocket sub-assembly.

    Standard Clearance:
    1.18 to 2.22 mm (0.0465 to 0.0874 in.)

    Minimum Clearance:
    1.18 mm (0.0465 in.)

    If the clearance is not as specified, replace the transfer synchronizer ring set with a new one.