CANISTER > REMOVAL |
| 1. DISCONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY |
![]() |
Pull up the retainer and disconnect the vent line hose.
Remove the bolt.
| 2. DISCONNECT NO. 1 CHARCOAL CANISTER OUTLET HOSE |
![]() |
Disconnect the No. 1 charcoal canister outlet hose.
| 3. REMOVE CHARCOAL CANISTER ASSEMBLY |
![]() |
Disconnect the charcoal canister outlet hose.
![]() |
Remove the 3 bolts and charcoal canister assembly.
| 4. REMOVE FUEL TANK VENT HOSE SUB-ASSEMBLY |
![]() |
Push the hose firmly toward the canister side.
Pinch the hose (portion A) as shown in the illustration.
Pull out the hose.
| 5. REMOVE CHARCOAL CANISTER BASE BRACKET |
![]() |
Disconnect the No. 2 canister outlet hose sub-assembly.
Push the hose firmly toward the canister side.
Pinch the hose (portion A) as shown in the illustration.
Pull out the hose.
Remove the charcoal canister filter sub-assembly.
Disconnect the charcoal canister outlet hose from hose clamp.
![]() |
Remove the hose clamp.
![]() |
Remove the 2 bolts and charcoal canister base bracket.
| 6. REMOVE CHARCOAL CANISTER SUPPORT BRACKET |
![]() |
Remove the 2 bolts and charcoal canister support bracket.
| 7. REMOVE NO. 1 CHARCOAL CANISTER OUTLET HOSE |
![]() |
Remove the No. 1 charcoal canister outlet hose.
| 8. REMOVE CHARCOAL CANISTER OUTLET HOSE |
![]() |
Remove the charcoal canister outlet hose.
| 9. REMOVE CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY |
Before removing the charcoal canister leak detection pump, clean the canister by blowing air into it to ensure that the canister is free of foreign matter.
![]() |
Disconnect the vacuum hose.
Remove the 3 bolts and charcoal canister leak detection pump.
Check if the canister contains foreign matter such as mud or water.
![]() |
Visually check that the inside of the canister is free of foreign matter.
Hold the canister upside down to make sure that the canister is free of foreign matter.
If the canister contains foreign matter, replace the canister.