3UR-FE STARTING > SERVICE DATA |
| Starter assembly | Specified current: 190 A or less at 11.5 V |
| Starter armature assembly | Standard resistance: Commutator: Below 1 Ω Commutator - Armature core: 10 kΩ or higher |
| Standard diameter: 35.0 mm (1.38 in.) Minimum diameter: 34.0 mm (1.34 in.) Standard undercut depth: 0.7 mm (0.0276 in.) Minimum undercut depth: 0.2 mm (0.00787 in.) Maximum circle runout: 0.05 mm (0.00197 in.) | |
| Brush length | Standard brush length: 15.0 mm (0.591 in.) Minimum brush length: 9.0 mm (0.354 in.) |
| Starter brush holder assembly | Standard resistance: Positive (+) brush holder - Negative (-) brush holder: 10 kΩ or higher |
| Standard spring installed load: 22 to 28 N (2 to 3 kgf, 4.8 to 6.2 lbf) Minimum spring installed load: 12 N (1 kgf, 2.8 lbf) | |
| Starter yoke assembly | Standard resistance: Terminal C wire - Brushes: Below 1 Ω |
| Standard resistance: Brushes - Starter yoke body: 10 kΩ or higher | |
| Magnet starter switch assembly | Standard resistance: Terminal 50 - Terminal C: Below 1 Ω |
| Standard resistance: Terminal 50 - Switch body: Below 2 Ω | |
| Starter relay | 3 - 5: 10 kΩ or higher (When battery voltage is not applied to terminals 1 and 2) 3 - 5: Below 1Ω (When battery voltage is applied to terminals 1 and 2) |
| ACC relay (Main body ECU) | DD-47 - DD-8: 10 kΩ or higher (When battery voltage is not applied between DD-45 and DD-62) DD-47 - DD-8: Below 1 Ω (When battery voltage is applied between DD-45 and DD-62) |
| ACC cut relay | 3 - 4: Below 1 Ω (When battery voltage is not applied to terminals 1 and 2) 3 - 4: 10 kΩ or higher (When battery voltage is applied to terminals 1 and 2) 3 - 5: 10 kΩ or higher (When battery voltage is not applied to terminals 1 and 2) 3 - 5: Below 1 Ω (When battery voltage is applied to terminals 1 and 2) |