FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat) |
Remove the front seat assembly (Click here).
| 3. REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat) |
Remove the front seat assembly (Click here ).
| 4. REMOVE FRONT DOOR SCUFF PLATE RH |
![]() |
Detach the 9 claws and remove the scuff plate.
| 5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Remove the front door opening trim weatherstrip.
| 6. REMOVE REAR FLOOR STEP NO. 1 COVER |
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cap.
| 7. REMOVE REAR DOOR SCUFF PLATE RH |
![]() |
Remove the bolt.
Detach the 5 clips, 6 claws and 2 guides, and remove the rear door scuff plate front side.
![]() |
Remove the 2 bolts.
Detach the 5 clips and 2 claws, and remove the scuff plate rear side.
| 8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Remove the rear door opening weatherstrip.
| 9. REMOVE LOWER CENTER PILLAR GARNISH RH |
![]() |
Detach the 3 claws and remove the outer lap belt anchor cover.
![]() |
Remove the bolt and outer lap belt anchor.
![]() |
Detach the 7 clips and 2 claws, and remove the center pillar garnish.
| 10. REMOVE CENTER PILLAR GARNISH RH |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the 2 assist grip plugs.
Remove the 2 bolts and assist grip.
Remove the bolt.
Detach the clip and guide.
Pass the front seat outer belt floor anchor through the center pillar garnish, and remove the center pillar garnish.

| 11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the nut and shoulder anchor.
![]() |
Disconnect the pretensioner connector as shown in the illustration.
![]() |
Remove the 2 bolts and front seat outer belt.
| 12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
![]() |
Remove the 2 bolts and front seat shoulder belt anchor adjuster assembly.