Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Rear Magnetic Valve Circuit

for Preparation Click here


DESCRIPTION

The rear cooling unit expansion valve is controlled by the air conditioning amplifier assembly.

WIRING DIAGRAM


E181900E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (REAR COOLING UNIT EXPANSION VALVE)
  1. Select the Active Test, use the intelligent tester to generate a control command, and then check that the rear cooling unit expansion valve operates.

    OK:
    Rear cooling unit expansion valve operates normally.


    Air Conditioner 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Rear A/C Mag Valve
    Rear Cooling Unit Expansion Valve
    ON or OFF
    -



NG
Go to step 2
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)  

2.INSPECT FUSE (A/C IG)


    E160643E13
  1. Remove the A/C IG fuse from the cowl side junction block LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A/C IG fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3.CHECK HARNESS AND CONNECTOR (REAR COOLING UNIT EXPANSION VALVE - BATTERY)


    E181911E01
  1. Disconnect the P24 rear cooling unit expansion valve connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    P24-1 (+S) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (REAR COOLING UNIT EXPANSION VALVE - AIR CONDITIONING AMPLIFIER)
E181912E02
  1. Disconnect the P24 rear cooling unit expansion valve connector.

  1. Disconnect the H24 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    P24-2 (RMGV) - H24-19 (RMGV)
    Always
    Below 1 Ω
    P24-2 (RMGV) - Body ground
    Always
    10 kΩ or higher
    H24-19 (RMGV) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK REAR COOLING UNIT EXPANSION VALVE (OPERATION)
  1. Replace the rear cooling unit expansion valve (Click here).

    HINT:
    Since the rear cooling unit expansion valve cannot be inspected while it is removed from the vehicle, replace the rear cooling unit expansion valve with a normal one and check that the condition returns to normal.

    OK:
    Same problem does not occur.



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE REAR COOLING UNIT EXPANSION VALVE (Click here)