Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


  1. Hold down the window deflector.

    NOTICE:
    Make sure that the spring indicated by the arrow in the illustration is securely installed.

    B191422

  1. Slide the drive cable in the direction indicated by the arrow in the illustration to install it.



    B191840
  1. Slide each roof wind deflector lifter link in the direction indicated by the arrow in the illustration to install it, and then attach the claw.



2. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


B170257E01
  1. Using a screwdriver with its tip wrapped in protective tape, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.



3. INSTALL ROOF REAR DRIP CHANNEL


  1. Attach the 2 claws to install the drip channel.


    B191812



4. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    B191811
  1. Insert the sunshade trim into the sliding roof housing.



    B191415
  1. Install the sliding roof piece LH and RH.

  1. Install the screw.



5. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


B191419
  1. Install the drive gear and room light bracket with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSTALL SLIDING ROOF HOUSING REAR MOUNTING BRACKET RH


    B193650
  1. Install the rear mounting bracket with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



7. INSTALL SLIDING ROOF HOUSING REAR MOUNTING BRACKET LH

HINT:
Use the same procedure for the RH side and LH side.