Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
  1. Pass the hood lock control cable assembly into the engine compartment.

  1. Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.

  1. Pass the cable front side through the upper radiator support.



  1. Attach the cable to the clamps as shown in the illustration.


    B220217E01



2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.

  1. Attach the 3 claws to install the hood lock lever



3. INSTALL HOOD LOCK ASSEMBLY


    B166025
  1. Apply MP grease to the sliding areas of the lock.

  1. Connect the connector.



    B220936
  1. Connect the hood lock control cable.

  1. Install the hood lock.

  1. Install the 2 bolts and nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


    1. Adjust the hood lock .

    2. Inspection the hood lock .



    B220935
  1. Install a new hood lock nut cap.



4. INSTALL HOOD LOCK CONTROL CABLE COVER


    B223272
  1. Attach the clamp and install the hood lock control cable cover.

  1. Install the screw.

  1. Install the nut.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }



    B223275
  1. Install a new hood lock nut cap.