Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE HOOD LOCK CONTROL CABLE COVER


    B223274
  1. Using a screwdriver with its tip wrapped in protective tape, remove the hood lock nut cap.



    B223272
  1. Remove the screw and nut.

  1. Detach the claw and remove the hood lock control cover.



2. REMOVE HOOD LOCK ASSEMBLY


    B220937
  1. Using a screwdriver with its tip wrapped in protective tape, remove the hood lock nut cap.



    B220936
  1. Remove the 2 bolts and nut.

  1. Remove the hood lock.

  1. Disconnect the connector.

  1. Disconnect the hood lock control cable.



3. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Detach the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



4. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.


    B220217E01

  1. Pull the cable from the engine room and remove it.