Home › Engine / Hybrid System › 3UR-FE STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A162868
  1. Remove the nut, and disconnect the lead wire from the magnet starter switch.



    A162869
  1. Remove the 2 nuts and magnet starter switch.



2. REMOVE STARTER DRIVE HOUSING ASSEMBLY


    A162870
  1. Using a T30 "TORX" socket wrench, remove the 2 bolts.

  1. Pull out the starter yoke and starter commutator end frame together with the starter armature.



3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    A162871
  1. Remove the starter pinion drive lever.



    A162872
  1. Remove the 2 screws and starter commutator end frame.

    NOTICE:
    While holding down the lead wire, remove the starter commutator end frame.



4. REMOVE STARTER ARMATURE ASSEMBLY


A030137E02
  1. Using a screwdriver, hold the spring back and disconnect the brush from the starter brush holder.

  1. Disconnect the 4 brushes and remove the starter brush holder.



    A146942
  1. Remove the starter armature from the starter yoke.



5. REMOVE STARTER YOKE ASSEMBLY
  1. Remove the starter yoke from the starter center bearing clutch.



6. REMOVE STARTER ARMATURE PLATE


A149624
  1. Remove the starter armature plate from the starter center bearing clutch.



7. REMOVE PLANETARY GEAR


A146943
  1. Remove the 3 planetary gears.