Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

DTC    U0129    Lost Communication with Brake System Control Module

for Preparation Click here


DESCRIPTION

The combination meter communicates with the skid control ECU via the CAN line.

DTC Code
DTC Detection Condition
Trouble Area
U0129
When either of following conditions is detected:
  1. 15 seconds have elapsed since engine started and IG voltage 10.5 V or more
  2. No communication with skid control ECU continues for 3 seconds or more (No communication with ECM or skid control ECU continues for 60 seconds or more)
CAN communication system

WIRING DIAGRAM


E140490E20


INSPECTION PROCEDURE

1.CHECK DTC
  1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
    Result 
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B

    HINT:
    If the CAN communication system DTC U0129 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0129 first.



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)