CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL STUD BOLT |
Using E7 and E8 "TORX" socket wrenches, install the stud bolts.

| 2. INSTALL NO. 2 STRAIGHT SCREW PLUG |
![]() |
Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 straight screw plugs.
| 3. INSTALL NO. 1 STRAIGHT SCREW PLUG |
![]() |
Using a 10 mm hexagon wrench, install 6 new gaskets and the 6 straight screw plugs.
| 4. INSTALL VALVE SPRING SEAT |
Install the valve spring seats to the cylinder head.
| 5. INSTALL VALVE STEM OIL SEAL |
![]() |
Apply a light coat of engine oil to new oil seals.
![]() |
Using SST, push in the oil seals.
| 6. INSTALL INTAKE VALVE |
![]() |
Apply plenty of engine oil to the tip area of the intake valve shown in the illustration.
Install the valve, compression spring and spring retainer to the cylinder head.
![]() |
Using SST and wooden blocks, compress the spring and install the retainer locks.
![]() |
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.
| 7. INSTALL EXHAUST VALVE |
![]() |
Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.
Install the valve, compression spring and spring retainer to the cylinder head.
![]() |
Using SST and wooden blocks, compress the spring and install the retainer locks.
![]() |
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.