WIPER AND WASHER SYSTEM > Headlight Cleaner Switch Circuit |

| 1.CHECK HEADLIGHT ASSEMBLY (LO BEAM) |
Check that the headlights illuminate in LO beam.
|
| ||||
| OK | |
| 2.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY |
![]() |
Remove the headlight cleaner switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (L) - 8 (B) | Headlight cleaner switch OFF | 10 kΩ or higher |
| Headlight cleaner switch ON | Below 1 Ω |
Reinstall the headlight cleaner switch assembly.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY AND MAIN BODY ECU) |
![]() |
Disconnect the A32 headlight cleaner control relay connector.
Disconnect the H59 headlight cleaner switch assembly connector.
Disconnect the DD main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A32-2 (H) - H59-8 (B) | Always | Below 1 Ω |
| A32-2 (H) or H59-8 (B) - Body ground | Always | 10 kΩ or higher |
| H59-5 (L) - DD-23 (HRLY) | Always | Below 1 Ω |
| H59-5 (L) or DD-23 (HRLY) - Body ground | Always | 10 kΩ or higher |
Reconnect the headlight cleaner control relay connector.
Reconnect the headlight cleaner switch assembly connector.
Reconnect the main body ECU connector.
|
| ||||
| OK | ||
| ||