Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Headlight Cleaner Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the conditions of the headlight cleaner switch.
  1. Headlight cleaner switch signal
  2. Headlight operating signal

WIRING DIAGRAM


E162509E01


INSPECTION PROCEDURE

1.CHECK HEADLIGHT ASSEMBLY (LO BEAM)
  1. Check that the headlights illuminate in LO beam.

    OK:
    Headlights illuminate in LO beam



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY


    E157699E03
  1. Remove the headlight cleaner switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (L) - 8 (B)
    Headlight cleaner switch OFF
    10 kΩ or higher
    Headlight cleaner switch ON
    Below 1 Ω

  1. Reinstall the headlight cleaner switch assembly.



NG
REPLACE HEADLIGHT CLEANER SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY AND MAIN BODY ECU)


    B186565E02
  1. Disconnect the A32 headlight cleaner control relay connector.

  1. Disconnect the H59 headlight cleaner switch assembly connector.

  1. Disconnect the DD main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A32-2 (H) - H59-8 (B)
    Always
    Below 1 Ω
    A32-2 (H) or H59-8 (B) - Body ground
    Always
    10 kΩ or higher
    H59-5 (L) - DD-23 (HRLY)
    Always
    Below 1 Ω
    H59-5 (L) or DD-23 (HRLY) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the headlight cleaner control relay connector.

  1. Reconnect the headlight cleaner switch assembly connector.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HEADLIGHT CLEANER CONTROL RELAY