Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



  1. Tighten the radiator drain cock plug by hand.


    A151835E01



2. REMOVE V-BANK COVER SUB-ASSEMBLY


A165576E03
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



3. REMOVE AIR CLEANER HOSE ASSEMBLY


A187008
  1. Disconnect the vacuum hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



4. REMOVE THROTTLE W/MOTOR BODY ASSEMBLY


A158612
  1. Disconnect the No. 4 water by-pass hose.

  1. Disconnect the No. 5 water by-pass hose.

  1. Disconnect the throttle W/ motor body connector.



    A158613
  1. Remove the 4 bolts, throttle W/ motor body and gasket.

  1. Remove the No. 4 water by-pass hose from the throttle W/ motor body.

  1. Remove the No. 5 water by-pass hose from the throttle W/ motor body.