Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



  1. Tighten the radiator drain cock plug by hand.


    A151835E01



2. REMOVE V-BANK COVER SUB-ASSEMBLY


    A165576E04
  1. Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
    Text in Illustration 
    *1
    V-bank Cover Grommet
    *2
    Pin
    *3
    No. 1 V-bank Cover Bracket
    *4
    V-bank Cover Hook



3. REMOVE AIR CLEANER HOSE ASSEMBLY


    A187008
  1. Disconnect the vacuum hose from the air cleaner hose assembly.

  1. Slide the clamp and disconnect the ventilation hose from the air cleaner hose assembly.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose assembly.



4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY


    A271499
  1. Slide the clamp and disconnect the No. 4 water by-pass hose from the front water by-pass joint sub-assembly.

  1. Slide the clamp and disconnect the No. 5 water by-pass hose from the water inlet housing.

  1. Disconnect the throttle with motor body connector.



    A158613
  1. Remove the 4 bolts, throttle with motor body and gasket.

  1. Slide the clamp and remove the No. 4 water by-pass hose from the throttle with motor body assembly.

  1. Slide the clamp and remove the No. 5 water by-pass hose from the throttle with motor body assembly.