Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

DTC    B1500    Fuel Sender Open Detected

for Preparation Click here


DESCRIPTION

This DTC is stored when the combination meter detects the fuel sender gauge malfunction.

DTC Code
DTC Detection Condition
Trouble Area
B1500
When combination meter detects fuel sender gauge malfunction
  1. Harness or connector
  2. Combination meter
  3. Fuel sender gauge
  4. Fuel suction with pump and gauge tube

WIRING DIAGRAM


E182026E01


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (FUEL SENDER GAUGE)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Combination Meter / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Fuel Input
    Fuel sender gauge (main) input signal/Min.: 0, Max.: 127.5
    Fuel sender input value
    Unit: L

    OK:
    Fuel value displayed on the intelligent tester is almost same as needle indication.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - FUEL SENDER GAUGE AND BODY GROUND)


    E146742E03
  1. Disconnect the H37 meter connector.

  1. Disconnect the Q1 gauge connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H37-12 (L) - Q1-2 (FS)
    Always
    Below 1 Ω
    H37-39 (E3) - Q1-3 (FE)
    Always
    Below 1 Ω
    H37-40 (E1) - Body ground
    Always
    Below 1 Ω
    H37-12 (L) or Q1-2 (FS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT FUEL SUCTION WITH PUMP AND GAGE TUBE ASSEMBLY
E180164E03
  1. Remove the fuel suction with pump and tube assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (FS) - 2 (FS)
    Always
    Below 1 Ω
    3 (FE) - 3 (FE)



NG
REPLACE FUEL SUCTION WITH PUMP AND GAGE TUBE ASSEMBLY (Click here)
OK


4.INSPECT FUEL SENDER GAUGE ASSEMBLY


    A156397E02
  1. Remove the fuel sender gauge (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (FS) - 3 (FE)
    Float level is F (upper)
    12 to 18 Ω
    Float level is E (lower)
    405 to 415 Ω



NG
REPLACE FUEL SENDER GAUGE ASSEMBLY (Click here)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)