Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B1273    Sliding Roof ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the sliding roof drive gear sub-assembly and main body ECU stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B1273
No communication between the sliding roof drive gear sub-assembly and main body ECU for 10 seconds or more.
  1. Sliding roof drive gear sub-assembly
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM


B173719E30


INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

HINT:
DTC B2325 is stored when the communication between the sliding roof ECU and main body ECU stops.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF ECU)


    E160668E02
  1. Disconnect the H2 main body ECU connector.

  1. Disconnect the U3 sliding roof drive gear sub-assembly connector.
    Measure the resistance according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H2-10 (LIN2) - U3-3 (MPX1)
    Always
    Below 1 Ω
    H2-10 (LIN2) or U3-3 (MPX1) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the main body ECU connector.

  1. Reconnect the sliding roof drive gear sub-assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU - BATTERY AND BODY GROUND)


    E160669E03
  1. Disconnect the U3 sliding roof drive gear sub-assembly connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U3-8 (E) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    U3-10 (B) - Body ground
    Always
    11 to 14 V

  1. Reconnect the sliding roof drive gear sub-assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
  1. Temporarily replace the sliding roof drive gear sub-assembly with a new or normally functioning one .

  1. Clear the DTC (Click here).


NEXT


4.CHECK FOR DTC
  1. Recheck for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1273 is not output
    A
    DTC B1273 is output
    B



B
REPLACE MAIN BODY ECU
A

END (SLIDING ROOF ECU IS DEFECTIVE)