Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B1206    P/W Master Switch Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the power window regulator master switch assembly and main body ECU stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B1206
No communication between the master switch and main body ECU for 10 seconds or more.
  1. Power window regulator master switch assembly
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM


B173719E29


INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

HINT:
DTC B2325 is stored when the communication between the master switch and main body ECU stops.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - MASTER SWITCH)


    E160666E01
  1. Disconnect the H2 main body ECU connector.

  1. Disconnect the M2 power window regulator master switch assembly connector.

  1. Measure the resistance according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H2-10 (LIN2) - M2-6 (LIN1)
    Always
    Below 1 Ω
    H2-10 (LIN2) or M2-6 (LIN1) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the main body ECU connector.

  1. Reconnect the power window regulator master switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (MASTER SWITCH - BATTERY AND BODY GROUND)


    E160667E03
  1. Disconnect the M2 power window regulator master switch assembly connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M2-1 (E) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    M2-3 (B) - Body ground
    Always
    11 to 14 V

  1. Reconnect the power window regulator master switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
  1. Temporarily replace the power window regulator master switch assembly with a new or normally functioning one (Click here).

  1. Clear the DTC (Click here).


NEXT


4.CHECK FOR DTC
  1. Recheck for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1206 is not output
    A
    DTC B1206 is output
    B



B
REPLACE MAIN BODY ECU
A

END (MASTER SWITCH IS DEFECTIVE)