Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK SENSOR


    A184969E03
  1. Install the 4 knock sensor with the 4 bolts so that the knock sensors are angled as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    Text in Illustration 
    *a
    Bank 2 Sensor 1
    *b
    Bank 1 Sensor 1
    *c
    Bank 2 Sensor 2
    *d
    Bank 1 Sensor 2
    *e
    Front
    *f
    Upper
    *g
    Rear

    NOTICE:
    The acceptable installation angle of the knock sensor is between 10° upward and 2° downward from the horizontal position.

  1. Connect the 4 knock sensor connectors.



2. INSTALL NO. 1 ENGINE COVER


A158656

NOTICE:
Make sure that the No. 1 engine cover is level with the top surface of the intake port of the cylinder head for 1 and 2.

  1. Install the No. 1 engine cover.

    HINT:
    1. Align the No. 1 engine cover cutouts with the air tube.
    2. Align the No. 1 engine cover with the electric air control valve surface and cylinder head wall.



3. INSTALL NO. 2 CYLINDER HEAD COVER


A158538

NOTICE:
Make sure that the No. 2 cylinder head cover is level with the top surface of the intake port of the cylinder head.

  1. Install the No. 2 cylinder head cover.

    HINT:
    1. Align the No. 2 cylinder head cover cutout with the air tube.
    2. Align the No. 2 cylinder head cover with the front water by-pass joint and cylinder head wall.



4. INSTALL INTAKE MANIFOLD
(Click here)