Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER

COMBINATION METER > INSTALLATION

for Preparation Click here



1. INSTALL COMBINATION METER ASSEMBLY


    E141678
  1. Connect the connector and attach the clip.



    E161309
  1. Install the combination meter assembly with the 4 screws.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Attach the 12 clips to install the finish panel.

  1. Connect the 2 connectors and clamp.

  1. Attach the 4 claws to install the instrument panel finish panel retainer.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



4. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



5. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



6. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



8. CHECK SRS WARNING LIGHT
(Click here)