Home › Vehicle Interior › METER / GAUGE / DISPLAY › LIGHT CONTROL RHEOSTAT

LIGHT CONTROL RHEOSTAT > INSPECTION

for Preparation Click here



1. INSPECT LIGHT CONTROL RHEOSTAT (w/o TAIL Cancel Switch)


  1. Measure the resistance according to the value(s) in the table below.


    E142878E01

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (RV) - 1 (E)
    Downside → Upside
    See illustration
    7 (T) - 1 (E)
    Always
    8 to 12 kΩ

    If the result is not as specified, replace the rheostat.



2. INSPECT LIGHT CONTROL RHEOSTAT (w/ TAIL Cancel Switch)


  1. Measure the resistance according to the value(s) in the table below.


    E142879E01

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (RV) - 1 (E)
    Downside → Upside
    See illustration
    5 (TC) - 7 (T)
    Downside → Upside
    10 kΩ or higher → Below 1 Ω
    7 (T) - 1 (E)
    Always
    8 to 12 kΩ

    If the result is not as specified, replace the rheostat.