Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


  1. Check the resistance of the light control switch.



      E146065E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      12 (EL) - 18 (T)
      TAIL
      Below 1 Ω
      12 (EL) - 18 (T)
      HEAD
      Below 1 Ω
      12 (EL) - 20 (H)
      HEAD
      Below 1 Ω
      12 (EL) - 19 (A)
      AUTO
      Below 1 Ω

      If the result is not as specified, replace the headlight dimmer switch assembly.

  1. Check the resistance of the headlight dimmer switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      11 (HU) - 12 (EL)
      FLASH
      Below 1 Ω
      17 (HF) - 12 (EL)
      FLASH
      Below 1 Ω
      16 (HL) - 12 (EL)
      LOW BEAM
      Below 1 Ω
      11 (HU) - 12 (EL)
      HI BEAM
      Below 1 Ω

      If the result is not as specified, replace the headlight dimmer switch assembly.

  1. Check the resistance of the turn signal switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      12 (EL) - 13 (TR)
      Right turn
      Below 1 Ω
      12 (EL) - 13 (TR)
      12 (EL) - 15 (TL)
      Neutral
      10 kΩ or higher
      12 (EL) - 15 (TL)
      Left turn
      Below 1 Ω

      If the result is not as specified, replace the headlight dimmer switch assembly.

  1. Check the resistance of the fog light switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      3 (LFG) - 4 (BFG)
      ON
      Below 1 Ω
      3 (LFG) - 4 (BFG)
      OFF
      10 kΩ or higher

      If the result is not as specified, replace the headlight dimmer switch assembly.