Home › Vehicle Interior › INTERIOR PANELS / TRIM › FRONT CONSOLE BOX (w/ Cool Box)

FRONT CONSOLE BOX (w/ Cool Box) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.



    E181845E02
  1. Remove the caps from the service valves on the refrigerant line.
    Text in Illustration 
    *1
    Low Pressure Service Valve
    *2
    High Pressure Service Valve

  1. Connect the refrigerant recovery unit.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

    NOTICE:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



3. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure for both sides.



5. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



6. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Detach the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B229064
  1. Remove the 2 <A> bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B161742
  1. Detach the 12 clips and remove the console panel.



10. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    B222976
  1. Move the shift lever to N.

  1. Remove the clip.

  1. Detach the 6 clips and remove the console panel.

  1. Disconnect the connector



11. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY


    B262023
  1. Remove the 2 bolts and disconnect the air conditioner tube and accessory assembly from the cooling box assembly.

  1. Remove the 2 O-rings from the air conditioner tube and accessory assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



12. REMOVE COOLING BOX TRAY


    B262024
  1. Remove the cooling box tray.



13. REMOVE COOLING BOX ASSEMBLY


    B262025
  1. Disconnect the 3 connectors.



    B262026
  1. Remove the 4 bolts.

  1. Remove the 4 No. 1 cool box packings.



    B262027
  1. Detach the 4 clips and claw, and remove the cooling box assembly.



14. REMOVE REAR CONSOLE BOX ASSEMBLY


    B262028
  1. Disconnect the 2 connectors.



    B262029
  1. Remove the 4 bolts and 2 screws.

  1. Detach the 6 claws and remove the rear console box.



15. REMOVE FRONT CONSOLE BOX


    B222975
  1. Detach the 2 clamps.

  1. Remove the 2 clips.

  1. Remove the 5 screws and the front console box.