FRONT CONSOLE BOX (w/ Cool Box) > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Switch A/C ON.
Turn the blower switch to ON.
Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.
Stop the engine.
![]() |
Remove the caps from the service valves on the refrigerant line.
| *1 | Low Pressure Service Valve |
| *2 | High Pressure Service Valve |
Connect the refrigerant recovery unit.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
| 2. REMOVE FRONT DOOR SCUFF PLATE LH |
| 3. REMOVE COWL SIDE TRIM BOARD LH |
| 4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
| 5. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 6. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Detach the 3 claws.
Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.
| 7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the 2 <A> bolts.
Detach the 9 clips and claw.
![]() |
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
| 9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Detach the 12 clips and remove the console panel.
| 10. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Move the shift lever to N.
Remove the clip.
Detach the 6 clips and remove the console panel.
Disconnect the connector.
| 11. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY |
![]() |
Remove the 2 bolts and disconnect the air conditioner tube and accessory assembly from the cooling box assembly.
Remove the 2 O-rings from the air conditioner tube and accessory assembly.
| 12. REMOVE COOLING BOX TRAY |
![]() |
Remove the cooling box tray.
| 13. REMOVE COOLING BOX ASSEMBLY |
![]() |
Disconnect the 3 connectors.
![]() |
Remove the 4 bolts.
Remove the 4 No. 1 cool box packings.
![]() |
Detach the 4 clips and claw, and remove the cooling box assembly.
| 14. REMOVE REAR CONSOLE BOX ASSEMBLY |
![]() |
Disconnect the 2 connectors.
![]() |
Remove the 4 bolts and 2 screws.
Detach the 6 claws and remove the rear console box.
| 15. REMOVE FRONT CONSOLE BOX |
![]() |
Detach the 2 clamps.
Remove the 2 clips.
Remove the 5 screws and front console box.