FRONT CONSOLE BOX (w/o Cool Box) > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
| 2. REMOVE COWL SIDE TRIM BOARD LH |
| 3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
| 4. REMOVE FRONT PILLAR GARNISH LH |
| 5. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 6. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Detach the 3 claws.
Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.
| 7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the 2 <A> bolts.
Detach the 9 clips and claw.
![]() |
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
| 9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Detach the 12 clips and remove the console panel.
| 10. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Move the shift lever to N.
Remove the clip.
Detach the 6 clips and remove the console panel.
Disconnect the connector.
| 11. REMOVE REAR CONSOLE BOX POCKET |
![]() |
Remove the rear console box pocket.
| 12. REMOVE CONSOLE BOX CARPET |
![]() |
Remove the console box carpet.
| 13. REMOVE REAR CONSOLE BOX ASSEMBLY |
![]() |
Disconnect the connectors.
![]() |
Remove the 4 bolts and 2 screws.
Detach the 6 claws and remove the rear console box.
| 14. REMOVE FRONT CONSOLE BOX |
![]() |
Detach the 2 clamps.
Remove the 2 clips.
Remove the 5 screws and the front console box.