CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode | When either condition below is met:
|
|

| 1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A27 and D56 ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D56-81 (E1) - Body ground | Always | Below 1 Ω |
| D56-42 (E02) - Body ground | ||
| D56-43 (E01) - Body ground | ||
| D56-82 (ME01) - Body ground |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A27-1 (BATT) - Body ground | Always | 11 to 14 V |
| A27-2 (+B2) - Body ground | Battery positive (+) voltage is applied to terminal MREL | |
| A27-3 (+B) - Body ground | Battery positive (+) voltage is applied to terminal MREL | |
| A27-28 (IGSW) - Body ground | Ignition Switch ON |
|
| ||||
| OK | ||
| ||