Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
Either condition is met:
  1. "ECM (Engine)" is not displayed on the "Bus Check" screen.
  2. "ECM Communication Stop Mode" in "DTC Communication Table" applies.
  1. Power source or inside of ECM
  2. ECM

WIRING DIAGRAM


B210043E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND)


  1. Disconnect the A27 and D56 ECM connectors.


    C234869E03


    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)
    -
    -

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D56-81 (E1) - Body ground
    Always
    Below 1 Ω
    D56-42 (E02) - Body ground
    Always
    Below 1 Ω
    D56-43 (E01) - Body ground
    Always
    Below 1 Ω
    D56-82 (ME01) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A27-1 (BATT) - Body ground
    Always
    11 to 14 V
    A27-2 (+B2) - Body ground
    Battery positive (+) voltage is applied to terminal A27-34 (MREL)
    11 to 14 V
    A27-3 (+B) - Body ground
    Battery positive (+) voltage is applied to terminal A27-34 (MREL)
    11 to 14 V
    A27-28 (IGSW) - Body ground
    Ignition Switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)