CAN COMMUNICATION SYSTEM > Center Airbag Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Center Airbag Sensor Communication Stop Mode | Either condition is met:
|
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR ASSEMBLY CAN BRANCH WIRE) |
![]() |
Disconnect the H56 center airbag sensor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H56-13 (CANH) - H56-22 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Center Airbag Sensor Assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H56-25 (E1) - Body ground | Always | Below 1 Ω |
| H56-26 (E2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H56-21 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector (to Center Airbag Sensor Assembly) |
| Result | Proceed to |
| OK (w/ Cool Box) | A |
| OK (w/o Cool Box) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||