CAN COMMUNICATION SYSTEM > Main Body ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Main Body ECU Communication Stop Mode | When either condition below is met:
|
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (MAIN BODY ECU BRANCH WIRE) |
![]() |
Disconnect the H2 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H2-5 (CANH) - H2-6 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Main Body ECU) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND) |
Reconnect the cable to the negative (-) battery terminal.
Disconnect the DA, DB and DD main body ECU connectors.
Measure the resistance according to the value(s) in the table below.

| *a | Front view of wire harness connector (to Main Body ECU) | - | - |
| Tester Connection | Condition | Specified Condition |
| DD-62 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DA-1 (ALTB) - Body ground | Always | 11 to 14 V |
| DB-13 (BECU) - Body ground |
|
| ||||
| OK | ||
| ||