Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

DTC    U0208    Lost Communication with "Seat Control Module A"

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0208
No communication from power seat control ECU
  1. Power source circuit of power seat control ECU
  2. Power seat control ECU
  3. Power seat control ECU branch wire or connector
w/ Seat Memory

WIRING DIAGRAM


C158945E04


C158945E05


INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any other switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (POWER SEAT CONTROL ECU BRANCH WIRE)


    C159483E02
  1. Disconnect the X11 power seat control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    X11-5 (CANH) - X11-1 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE POWER SEAT CONTROL ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3.CHECK HARNESS AND CONNECTOR (POWER SEAT CONTROL ECU - BATTERY AND BODY GROUND)
  1. Reconnect the cable from the negative (-) battery terminal.



    C159482E02
  1. Disconnect the X10 and X11 power seat control ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    X10-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    X10-5 (+B) - Body ground
    Always
    11 to 14 V
    X11-8 (SYSB) - Body ground
    X11-4 (IG) - Body ground
    Ignition switch ON



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FRONT POWER SEAT SWITCH LH (Click here)