Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1441/41    Air Mix Damper Control Servo Motor Circuit (Passenger Side)

for Preparation Click here


DESCRIPTION

The damper servo sub-assembly (for front passenger side) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal, reverse) based on the signals to move the air mix damper (for front passenger side) to any position. As a result, the amount of air that has passed through the evaporator and is now passing through the heater core is adjusted, and the temperature of the air blowing toward the front passenger side is controlled.

HINT:
Confirm that no mechanical problem is present because this diagnostic trouble code can be stored when either a damper link or damper is mechanically locked.


DTC Code
DTC Detection Condition
Trouble Area
B1441/41
The air mix damper position does not change even if the air conditioning amplifier assembly operates the air mix servo motor.
  1. Damper servo sub-assembly (for front passenger side)
  2. Air conditioning harness assembly
  3. Air conditioning amplifier assembly

WIRING DIAGRAM


E180810E08


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (PASSENGER SIDE AIR MIX SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Mix Servo Targ Pulse (P)
    Passenger side air mix servo motor /
    Min.: 0
    Max.: 255
    MAX. COLD: 105 (pulse)
    MAX. HOT: 6 (pulse)
    -

    OK:
    The display is as specified in the normal condition.

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to the DTC output)
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    NG
    C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A


2.REPLACE DAMPER SERVO SUB-ASSEMBLY (for Front Passenger Side)
  1. Replace the damper servo sub-assembly (for front passenger side) (Click here).

    HINT:
    Since the damper servo motor cannot be inspected while it is removed from the vehicle, replace the damper servo motor with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1441 is not output.



NG
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)
OK

END (DAMPER SERVO SUB-ASSEMBLY IS FAULTY)