Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1442/42    Air Inlet Damper Control Servo Motor Circuit

for Preparation Click here


DESCRIPTION

The recirculation damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal, reverse) based on the signals to move the recirculation damper to any position, which controls the intake air settings (fresh, fresh/recirculation and recirculation).

HINT:
Confirm that no mechanical problem is present because this diagnostic trouble code can be stored when either a damper link or damper is mechanically locked.


DTC Code
DTC Detection Condition
Trouble Area
B1442/42
The recirculation damper position does not change even if the air conditioning amplifier assembly operates the recirculation damper servo motor.
  1. Recirculation damper servo sub-assembly
  2. Air conditioning harness assembly
  3. Air conditioning amplifier assembly

WIRING DIAGRAM


E180810E09


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (AIR INLET DAMPER SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Inlet Damper Targ Pulse
    Air inlet damper servo motor /
    Min.: 0
    Max.: 255
    Recirculation: 7
    Fresh: 28
    -

    OK:
    The display is as specified in the normal condition.

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to the DTC output)
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    NG
    C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A


2.REPLACE RECIRCULATION DAMPER SERVO SUB-ASSEMBLY
  1. Replace the recirculation damper servo sub-assembly (Click here).

    HINT:
    Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo motor with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1442 is not output.



NG
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)
OK

END (RECIRCULATION DAMPER SERVO SUB-ASSEMBLY IS FAULTY)