Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › TRANSPONDER KEY AMPLIFIER

TRANSPONDER KEY AMPLIFIER > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B229064
  1. Remove the 2 <A> bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



5. REMOVE LOWER STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column)


C181134
  1. Remove the 2 screws.

  1. Detach the 2 claws to remove the lower steering column cover.



6. REMOVE UPPER STEERING COLUMN COVER


    C159215
  1. Detach the 4 clips.

  1. Detach the claw to remove the upper steering column cover.



7. REMOVE TRANSPONDER KEY AMPLIFIER
  1. Disconnect the connector.



    B192527E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the transponder key amplifier.