Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › TRANSPONDER KEY AMPLIFIER

TRANSPONDER KEY AMPLIFIER > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B229064
  1. Remove the 2 <A> bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



5. REMOVE LOWER STEERING COLUMN COVER


    C181134
  1. Remove the 2 screws.

  1. Detach the 2 claws to remove the lower steering column cover.



6. REMOVE UPPER STEERING COLUMN COVER
  1. Detach the 4 clips.



    C159215
  1. Detach the claw to remove the upper steering column cover.



7. REMOVE TRANSPONDER KEY AMPLIFIER
  1. Disconnect the connector.



    B192527E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the transponder key amplifier.