Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

DTC    B1244    Light Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a failure of the automatic light control sensor circuit is detected.

DTC Code
DTC Detection Condition
Trouble Area
B1244
When either condition below is met:
  1. Malfunction of light sensor
  2. Open or short of light sensor circuit
  1. Automatic light control sensor
  2. Harness or connector
  3. Main body ECU (Cowl side junction block LH)

WIRING DIAGRAM


E132905E09


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Recheck for DTC (Click here).

    OK:
    DTC B1244 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.READ VALUE USING INTELLIGENT TESTER (AUTOMATIC LIGHT CONTROL SENSOR)
  1. Operate the intelligent tester according to the display and select Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Illumination Rate
    Illumination rate / min.: 0, max.: 99.99
    Actual illumination rate is displayed
    -

    OK:
    Output illumination is as shown in table above.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH) 

3.CHECK AUTOMATIC LIGHT CONTROL SENSOR (SYSTEM VOLTAGE)


    E107010E15
  1. Disconnect the I21 automatic light control sensor connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I21-6 (CLTB) - I21-3 (CLTE)
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

  1. Reconnect the automatic light control sensor connector.



NG
Go to step 4
OK

REPLACE AUTOMATIC LIGHT CONTROL SENSOR  

4.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - AUTOMATIC LIGHT CONTROL SENSOR)


    E140027E06
  1. Disconnect the H3 main body ECU connector.

  1. Disconnect the I21 automatic light control sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H3-20 (CLTB) - I21-6 (CLTB)
    Always
    Below 1 Ω
    H3-19 (CLTS) - I21-5 (CLTS)
    Always
    Below 1 Ω
    H3-18 (CLTE) - I21-3 (CLTE)
    Always
    Below 1 Ω
    H3-20 (CLTB) - Body ground
    Always
    10 kΩ or higher
    H3-19 (CLTS) - Body ground
    Always
    10 kΩ or higher
    H3-18 (CLTE) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the automatic light control sensor connector.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)