DTC B1244 Light Sensor Circuit Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1244 | When either condition below is met:
|
|

| 1.CHECK FOR DTC |
Clear the DTC (Click here).
Recheck for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 2.READ VALUE USING INTELLIGENT TESTER (AUTOMATIC LIGHT CONTROL SENSOR) |
Operate the intelligent tester according to the display and select Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Illumination Rate | Illumination rate / min.: 0, max.: 99.99 | Actual illumination rate is displayed | - |
|
| ||||
| OK | ||
| ||
| 3.CHECK AUTOMATIC LIGHT CONTROL SENSOR (SYSTEM VOLTAGE) |
![]() |
Disconnect the I21 automatic light control sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I21-6 (CLTB) - I21-3 (CLTE) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
Reconnect the automatic light control sensor connector.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - AUTOMATIC LIGHT CONTROL SENSOR) |
![]() |
Disconnect the H3 main body ECU connector.
Disconnect the I21 automatic light control sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H3-20 (CLTB) - I21-6 (CLTB) | Always | Below 1 Ω |
| H3-19 (CLTS) - I21-5 (CLTS) | Always | Below 1 Ω |
| H3-18 (CLTE) - I21-3 (CLTE) | Always | Below 1 Ω |
| H3-20 (CLTB) - Body ground | Always | 10 kΩ or higher |
| H3-19 (CLTS) - Body ground | Always | 10 kΩ or higher |
| H3-18 (CLTE) - Body ground | Always | 10 kΩ or higher |
Reconnect the automatic light control sensor connector.
Reconnect the main body ECU connector.
|
| ||||
| OK | ||
| ||