Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Bus Buffer ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Bus Buffer ECU Communication Stop Mode
Either condition is met:
  1. Accessory Gateway" is not displayed on the "Bus Check" screen.
  2. "Bus Buffer ECU Communication Stop Mode" in "DTC Communication Table" applies.
  1. Bus buffer ECU CAN branch wire or connector
  2. Bus buffer ECU
  1. For vehicles with an bus buffer ECU.

WIRING DIAGRAM


C245793E01


INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (BUS BUFFER ECU CAN BRANCH WIRE)


    C242858E01
  1. Disconnect the H66 bus buffer ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    H66-3 (CAN+) - H66-2 (CAN-)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to Bus Buffer ECU)



NG
REPAIR OR REPLACE BUS BUFFER ECU CAN BRANCH WIRE OR CONNECTOR (CAN+, CAN-)
OK

REPLACE BUS BUFFER ECU