Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Customize Setting / Illuminated Entry or Light Control.

  5. Select the setting by referring to the table below.

    Illuminated Entry 
    Display
    Default
    Content
    Setting
    Lighting Time
    15s
    Changes illumination duration after door closure
    (It will quickly fade out when turning ignition switch ON)
    7.5s/15s/30s
    I/L when ACC OFF
    ON
    Illuminates light when ignition switch turned to ACC → OFF
    (Room light illuminated when interior light switch set to DOOR)
    ON/OFF
    I/L ON W/Door Key Unlock
    ON
    Function to light up room light when unlocking with door key cylinder
    (Room light illuminated when interior light switch set to DOOR)
    ON/OFF

    Light Control 
    Display
    Default
    Content
    Setting
    Disp Ex ON Sen
    NORMAL
    Changes brightness when lowering lights such as combination meter indicator light, A/C indicator light, and clock light*2
    Light2/Light1/Normal/Dark1/Dark2
    Disp Ex OFF Sen
    NORMAL
    Changes brightness when canceling lowering lights such as combination meter indicator light, A/C indicator light, and clock light*3
    Light2/Light1/Normal/Dark1/Dark2
    Sensitivity
    NORMAL
    Function to adjust sensitivity of lighting illumination*1
    Light2/Light1/Normal/Dark1/Dark2

    HINT:
    *1: The sensitivity adjustment may be difficult to confirm. Check by driving the customer's vehicle.


    *1 
    Lighting brightness

    E107164

    Setting
    Dark2
    Dark1
    Normal
    Light1
    Light2

    *2 
    Brightness when lowering the lights

    E107164

    Setting
    Dark2
    Dark1
    Normal
    Light1
    Light2

    *3 
    Brightness when canceling the lowering of the lights

    E107164

    Setting
    Dark2
    Dark1
    Normal
    Light1
    Light2