Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Customize Setting.

  5. Select the setting by referring to the table below.

    Light Control 
    Display
    Default
    Content
    Setting
    Sensitivity
    Normal
    Function to adjust sensitivity of lighting illumination*1
    Light2/Light1/Normal/Dark1/Dark2

    HINT:
    *1: The sensitivity adjustment may be difficult to confirm. Check by driving the customer's vehicle.


    *1 
    Lighting brightness

    E107164

    Setting
    Dark2
    Dark1
    Normal
    Light1
    Light2

    Mirror ECU 
    Display
    Default
    Content
    Setting
    Foot Light
    15s
    Changes illumination duration after door closure
    OFF/7.5s/15s/30s