Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Fold Down Seat Type)

FRONT SEAT ASSEMBLY (for Fold Down Seat Type) > REMOVAL

for Preparation Click here



1. REMOVE PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT SEAT HEADREST ASSEMBLY
  1. Remove the front seat headrest assembly.



4. REMOVE FRONT INNER SEAT TRACK BRACKET COVER (w/ Cover)
  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B232181E01
  1. Using a screwdriver, detach the 4 claws in the order shown in the illustration and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER RH (w/ Cover)


    B232182E01
  1. Using a screwdriver, detach the 4 claws in the order shown in the illustration and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE SEAT TRACK COVER OUTER RH
  1. Lift up the seat track adjusting handle to move the seat to the foremost position.



    B191067
  1. Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE SEAT TRACK COVER INNER RH


    B200255
  1. Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE FRONT SEAT ASSEMBLY RH


    B191041
  1. Remove the 2 bolts.

  1. Lift up the seat track adjusting handle to move the seat to the rearmost position.



    B191042
  1. Remove the 2 bolts.

  1. Lift up the seat track adjusting handle to move the seat to the center position.

  1. Disconnect the seat wire connectors under the seat.

  1. Remove the front seat assembly from the vehicle.

    NOTICE:
    Be careful not to damage the vehicle body.