Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)

FRONT SEAT ASSEMBLY (for Power Seat) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below are for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. REMOVE FRONT SEAT HEADREST ASSEMBLY
  1. Remove the front seat headrest assembly.



3. REMOVE FRONT INNER SEAT TRACK BRACKET COVER (w/ Cover)
  1. Operate the power seat switch (slide switch) to move the seat to the rearmost position.



    B232176E01
  1. Using a screwdriver, detach the 4 claws in the order shown in the illustration and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH (w/ Cover)


    B232177E01
  1. Using a screwdriver, detach the 4 claws in the order shown in the illustration and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE SEAT TRACK COVER INNER LH
  1. Operate the power seat switch (slide switch) to move the seat to the foremost position.



    B191067
  1. Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE SEAT TRACK COVER LH


    B200255
  1. Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE FRONT SEAT ASSEMBLY LH (w/ Leg Support Adjustment Switch)
  1. Operate the power seat switch (slide switch) to move the seat to the foremost position.



    B191041
  1. Remove the 2 bolts.

  1. Operate the power seat switch (slide switch) to move the seat to the rearmost position.



    B194824
  1. Remove the 2 bolts.

  1. Operate the power seat switch (slide switch) to move the seat to the center position.



    B167188
  1. Operate the leg support adjustment switch to move the seat cushion to the open position.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the seat wire connectors under the seat.

  1. Remove the front seat assembly from the vehicle.

    NOTICE:
    Be careful not to damage the vehicle body.



8. REMOVE FRONT SEAT ASSEMBLY LH (w/o Leg Support Adjustment Switch)
  1. Operate the power seat switch (slide switch) to move the seat to the foremost position.



    B191041
  1. Remove the 2 bolts.

  1. Operate the power seat switch (slide switch) to move the seat to the rearmost position.



    B194824
  1. Remove the 2 bolts.

  1. Operate the power seat switch (slide switch) to move the seat to the center position.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the seat wire connectors under the seat.

  1. Remove the front seat assembly from the vehicle.

    NOTICE:
    Be careful not to damage the vehicle body.