POWER SEAT SWITCH (for Front Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat) |
Remove the front seat (Click here).
| 2. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat) |
Remove the front seat (Click here).
| 3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for Power Seat) |
![]() |
Apply protective tape around the cushion shield.
Using a screwdriver, detach the 2 claws and remove the knob.
| 4. REMOVE RECLINING POWER SEAT SWITCH KNOB (for Power Seat) |
![]() |
Using a screwdriver, detach the 2 claws and remove the knob.
| 5. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat) |
![]() |
Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle cap.
| 6. REMOVE VERTICAL ADJUSTING HANDLE LH (for Manual Seat) |
![]() |
Remove the 2 screws and vertical adjusting handle.
| 7. REMOVE VERTICAL SEAT ADJUSTER KNOB (for Manual Seat) |
![]() |
Using a screwdriver, remove the snap ring and vertical seat adjuster knob.
| 8. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat) |
![]() |
Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the release handle.
| 9. REMOVE FRONT SEAT CUSHION SHIELD LH (for Power Seat) |
![]() |
Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.
Remove the 2 screws.
![]() |
Remove the 3 screws.
Detach the 2 claws and remove the cushion shield.
Disconnect the connectors.
| 10. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat) |
![]() |
Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.
![]() |
Remove the 3 screws.
Detach 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.
Detach the wire harness clamp and disconnect the connector.
| 11. REMOVE FRONT POWER SEAT LUMBAR SWITCH (for Power Seat) |
![]() |
Disconnect the connector.
Remove the 2 screws and front power seat lumbar switch.
| 12. REMOVE FRONT POWER SEAT LUMBAR SWITCH (for Manual Seat) |
![]() |
Disconnect the connector.
Remove the 2 screws and front power seat lumbar switch.
| 13. REMOVE LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch) |
![]() |
Detach the 2 wire harness clamps.
Remove the 2 screws and leg support adjustment switch.
Disconnect the connector.
| 14. REMOVE FRONT POWER SEAT SWITCH LH (w/o Memory) |
![]() |
Disconnect the connector.
Remove the 3 screws and front power seat switch.