Home › Vehicle Interior › SEAT › POWER SEAT SWITCH (for Front Seat)

POWER SEAT SWITCH (for Front Seat) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below are for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)
  1. Remove the front seat (Click here).



2. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)
  1. Remove the front seat (Click here).



3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for Power Seat)


    B201567E02
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE RECLINING POWER SEAT SWITCH KNOB (for Power Seat)


    B201568E02
  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat)


    B190969
  1. Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle cap.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE VERTICAL ADJUSTING HANDLE LH (for Manual Seat)


    B190970
  1. Remove the 2 screws and vertical adjusting handle.



7. REMOVE VERTICAL SEAT ADJUSTER KNOB (for Manual Seat)


    B190971
  1. Using a screwdriver, remove the snap ring and vertical seat adjuster knob.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)


    B190972
  1. Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the release handle.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE FRONT SEAT CUSHION SHIELD LH (for Power Seat)


    B191013
  1. Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.

  1. Remove the 2 screws.



    B166945
  1. Remove the 3 screws.

  1. Detach the 2 claws and remove the cushion shield.

  1. Disconnect the connectors.



10. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)


    B190973
  1. Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.



    B190974E01
  1. Remove the 3 screws.

  1. Detach 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.

  1. Detach the wire harness clamp and disconnect the connector.



11. REMOVE FRONT POWER SEAT LUMBAR SWITCH (for Power Seat)


    B201589
  1. Disconnect the connector.

  1. Remove the 2 screws and front power seat lumbar switch.



12. REMOVE FRONT POWER SEAT LUMBAR SWITCH (for Manual Seat)


    B194037
  1. Disconnect the connector.

  1. Remove the 2 screws and front power seat lumbar switch.



13. REMOVE LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch)


    B191014
  1. Detach the 2 wire harness clamps.

  1. Remove the 2 screws and leg support adjustment switch.

  1. Disconnect the connector.



14. REMOVE FRONT POWER SEAT SWITCH LH (w/o Memory)


    B194038
  1. Disconnect the connector.

  1. Remove the 3 screws and front power seat switch.