LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat) > INSTALLATION |
| 1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH |
![]() |
Attach the 3 claws to install the bush.
![]() |
Install the lumbar support adjuster with the 2 screws.
Connect the lumbar support adjuster connector.
![]() |
Attach the 6 hooks to install the seatback springs.
Install the 2 springs.
| 2. INSTALL SEATBACK COVER WITH PAD |
![]() |
Install the seatback cover with pad to the seatback frame.
Lift the seatback cover and, using hog ring pliers, install 4 new hog rings to the seat frame.
Lift the seatback cover, connect the seatback cover bracket to the seat frame, and install the nut.
| 3. INSTALL FRONT SEAT HEADREST SUPPORT |
![]() |
Align the protruding portion of the front seat headrest support with the installation groove of the front seatback frame.
Attach the 4 claws to install the 2 headrest supports.
![]() |
Install the seatback cover wires.
Using hog ring pliers, install 2 new hog rings to the seat frame.
![]() |
Attach the hooks.
![]() |
Using hog ring pliers, install 3 new hog rings to the seat frame.
| 4. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 5. INSTALL FRONT SEAT CUSHION SHIELD INNER LH |
![]() |
Attach the wire harness clamp.
Attach the 3 claws in the order shown in the illustration, to install the cushion shield.
Install the screw.
| 6. INSTALL FRONT SEAT CUSHION SHIELD LH |
![]() |
Connect the connector and attach the wire harness clamp.
Attach the 3 claws in the order shown in the illustration, to install the front seat cushion shield.
Install the 3 screws.
![]() |
Using hog ring pliers, install the rubber band of the seatback cover to the seat frame with 2 new hog rings.
| 7. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH |
![]() |
Attach the claw to install the reclining adjuster release handle.
| 8. INSTALL VERTICAL SEAT ADJUSTER KNOB LH (for 8 Way Seat) |
![]() |
Install the snap ring to the vertical seat adjuster knob.
Install the vertical seat adjuster knob to the front seat.
| 9. INSTALL VERTICAL ADJUSTING HANDLE LH |
![]() |
Install the vertical adjusting handle with the 2 screws.
| 10. INSTALL VERTICAL SEAT ADJUSTER KNOB CAP |
![]() |
Attach the 2 claws to install the vertical adjuster handle cap.
| 11. INSTALL FRONT SEAT ASSEMBLY LH |
Install the front seat (Click here).