LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
Remove the front seat (Click here).
| 2. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP |
![]() |
Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle cap.
| 3. REMOVE VERTICAL ADJUSTING HANDLE LH |
![]() |
Remove the 2 screws and vertical adjusting handle.
| 4. REMOVE VERTICAL SEAT ADJUSTER KNOB LH |
![]() |
Using a screwdriver, remove the snap ring and vertical seat adjuster knob.
| 5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH |
![]() |
Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the release handle.
| 6. REMOVE FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.
![]() |
Remove the 3 screws.
Detach 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.
Detach the wire harness clamp and disconnect the connector.
| 7. REMOVE FRONT SEAT CUSHION SHIELD INNER LH |
![]() |
Remove the screw.
Detach the 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.
Detach the wire harness clamp.
| 8. REMOVE FRONT SEAT HEADREST ASSEMBLY |
| 9. REMOVE FRONT SEAT HEADREST SUPPORT |
![]() |
Remove the 3 hog rings.
![]() |
Detach the hooks.
![]() |
Remove the 2 hog rings and seatback cover wires.
![]() |
Detach the 4 claws and remove the 2 front seat headrest supports.
| 10. REMOVE SEATBACK COVER WITH PAD |
![]() |
Lift the seatback cover and remove the nut and seatback cover bracket from the seat frame.
Lift the seatback cover and remove the 4 hog rings and seatback cover with pad.
| 11. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH |
![]() |
Remove the 2 springs.
Detach the 6 hooks and remove the seatback spring.
![]() |
Disconnect the lumbar support adjuster connector.
Remove the 2 screws and lumbar support adjuster.
![]() |
Detach the 3 claws and remove the bush from the seat frame.