Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat)

LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat (Click here).



2. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP


    B190969
  1. Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle cap.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE VERTICAL ADJUSTING HANDLE LH


    B190970
  1. Remove the 2 screws and vertical adjusting handle.



4. REMOVE VERTICAL SEAT ADJUSTER KNOB LH


    B190971
  1. Using a screwdriver, remove the snap ring and vertical seat adjuster knob.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH


    B190972
  1. Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the release handle.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE FRONT SEAT CUSHION SHIELD LH


    B190973
  1. Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.



    B190974E01
  1. Remove the 3 screws.

  1. Detach 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.

  1. Detach the wire harness clamp and disconnect the connector.



7. REMOVE FRONT SEAT CUSHION SHIELD INNER LH


    B190975E01
  1. Remove the screw.

  1. Detach the 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.

  1. Detach the wire harness clamp.



8. REMOVE FRONT SEAT HEADREST SUPPORT


    B190982
  1. Remove the 3 hog rings.



    B190983
  1. Detach the hooks.



    B190984
  1. Remove the 2 hog rings and seatback cover wires.



    B191055
  1. Detach the 4 claws and remove the 2 front seat headrest supports.



9. REMOVE SEATBACK COVER WITH PAD


    B190986
  1. Lift the seatback cover and remove the nut and seatback cover bracket from the seat frame.

  1. Lift the seatback cover and remove the 4 hog rings and seatback cover with pad.



10. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    B190989E03
  1. Remove the 2 springs.

  1. Detach the 6 hooks and remove the seatback spring.



    B190990
  1. Disconnect the lumbar support adjuster connector.

  1. Remove the 2 screws and lumbar support adjuster.



    B190994
  1. Detach the 3 claws and remove the bush from the seat frame.