REAR SEAT CUSHION HEATER > REMOVAL |
| 1. REMOVE REAR NO. 1 SEAT ASSEMBLY RH |
Remove the rear No. 1 seat assembly (Click here).
| 2. REMOVE RECLINING ADJUSTER KNOB CAP RH |
![]() |
Using a screwdriver, detach the 3 claws and remove the reclining adjuster knob cap.
| 3. REMOVE REAR SEAT RECLINING RELEASE LEVER |
![]() |
Remove the 3 screws and rear seat reclining release lever.
| 4. REMOVE REAR SEAT CUSHION HINGE COVER NO. 3 |
![]() |
Remove the screw.
Detach the 2 claws and remove the rear seat cushion hinge cover.
| 5. REMOVE REAR SEAT CUSHION HINGE COVER NO. 2 |
![]() |
Remove the screw.
Detach the 2 claws and remove the rear seat cushion hinge cover.
| 6. REMOVE REAR NO. 1 SEAT CUSHION ASSEMBLY RH |
![]() |
Disconnect the connector and detach the 3 clamps.
![]() |
Cut the cable tie.
Disconnect the cable from the seat cushion spring.
![]() |
Cut the cable tie to remove the cable from the seat cushion spring.
Detach the cable clamp and remove the cable from the seat cushion spring.
![]() |
Detach the 2 clamps to remove the cable from the seat cushion spring.
![]() |
Remove the 2 bolts.
Using a T45 "TORX" socket wrench, remove the 2 "TORX" bolts and 2 bushes. Then remove the rear No. 1 seat cushion.
| 7. REMOVE SEAT CUSHION COVER WITH PAD |
![]() |
Remove the 9 hog rings.
![]() |
Detach the hooks and remove the rear seat cushion spring.
| 8. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER |
![]() |
Remove the hog rings and separate type rear seat cushion cover.
| 9. REMOVE SEAT CUSHION HEATER ASSEMBLY |
![]() |
Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.